Valve amps - will the guitar sound be clean with a digital controller ?

Question:I want a valve sound that is clean and 'true', but I also want pre-sets. Someone said that digital pre-sets distort the valve sound.
Sites like http://www.delta-memotron.com say the signal path is un-interrupted and clean (through valves) so how do they use digital circuits to control valves without sending the signal through digital circuits ???

Best Answer - Chosen by Asker: I want a valve sound that is clean and 'true', but I also want pre-sets. Someone said that digital pre-sets distort the valve sound.
Sites like http://www.delta-memotron.com say the signal path is un-interrupted and clean (through valves) so how do they use digital circuits to control valves without sending the signal through digital circuits ???

First off, valves aren't meant to be "clean" or "true". Technically the reason we like tubes is that they distort fairly easily, but in a pleasing and musical way (largely 2nd order, etc). Just being picky. =)

Digital things can sound very "digital" in a tube amplifier depending on the quality of the DSP chip and how it's used.

It looks like what they're doing in this case is modifying the gain values of the tubes digitally. This doesn't actually interfere with the signal itself. It's kinda like using a digital thermometer to control your heater instead of an analog one, or turning it on and off by hand - the heat still comes out, the method of when and how much comes out is all that changes.

I'm very impressed with this amp.

Whoever said that digital presets distort the valve sound were talking about something else - maybe the Line 6 Spider 3 or something, where the distortion doesn't come from the valves but from a DSP chip. Your amp there is a different beast completely.

Saul

As long as the signal path isn't overloaded, the output can be clean in a tube circuit just like solid state. Pre-sets usually just vary the pre-amp signal before the power amp circuit. If you use a loop, you're taking the pre-amp signal, effecting it, and then giving it to the power amp. Some tube amps come with presets and effects now, like the Line 6. A tube amp purist will want nothing in the way of the tube circuits - they will just use the channels on the amp to switch between sound set-ups - like Clean & Distorted, etc.
It's not that a controller will "distort" the tone, it's just that it may "color" it somewhat.

Check out the new Line6 Spider Valve combo amps and heads
*digital amp modeling with artist presets
*Bogner Designed
*All Tube power and preamp
*reletively inexpensive for tube